Skip to content
  • In stock
Intake valve stem seals Nissan SR20 CA18 Intake valve stem seals Nissan SR20 CA18

SUPERTECH intake valve stem seals Nissan SR20 CA18

€7.54 (tax incl.)
€9.42 (tax incl.) -20%

Set of 8 intake valve stem seals for Nissan SR20 and CA18 four-cylinders, 6 mm stem.

  • Brand: SUPERTECH
  • Engines: CA18DE, CA18DET, SR20DE, SR20DEH, SR20DEL, SR20DET, SR20DNE, SR20VE
  • Material: Polyacrylate (ACM)
VS-N6I-8
11 in stock in Europe (72h lead time)
Available in stock in Europe (72h lead time)
Pay in installments

Nissan engines concerned

This set of 8 fits the 6 mm stem intake valves of Nissan 16-valve four-cylinders: the CA18DE and CA18DET of the Sunny, Bluebird, 200SX and 180SX, and the SR20 family (SR20DE, SR20DEH, SR20DEL, SR20DET, SR20DNE, SR20VE) of the Silvia, S13 to S15 200SX, Primera, Almera, Sunny, Bluebird, Avenir and Infiniti G20.

The head takes 8 intake valves, two per cylinder. Capping the guide, the original seal holds oil back and lets just enough through for the stem; Nissan gives it as 13207-84A00 (NDK) or 13207-D4201 (NOK), then 13207-53F00 (NOK) from 1994 on the SR20DET and 1996 on the SR20DE.

SUPERTECH inlet valve stem seals

At the top of the guide the stem seal dams the oil bathing the head while letting a thin film run down the stem; without that film, wear attacks the stem and its bore. Once its lip is tired by heat cycles, oil seeps in: more frequent top-ups, a blue cloud on start-up or after idling, fouled valves and plugs.

For the intake of these four-cylinders SUPERTECH uses polyacrylate (ACM), a rubber with good endurance, made for a 6 mm stem and a 10 mm outside diameter guide. These 8 pieces handle the full intake of the head; the exhaust, under more heat, has a separate high-temperature set.

Stem seal technical specifications

Part numberBrandPositionMaterialStem ØGuide ØSeal outside Ø
VS-N6I-8 SUPERTECH Inlet Polyacrylate (ACM) 6 mm 10 mm 12.6 mm

Stem seal installation

PartOriginalReinforced
Inlet stem seal Nissan 13207-84A00 / 13207-D4201 Replaced by this set
Exhaust stem seal Nissan 13207-84A00 / 13207-D4201 VS-N6E-8
Valve guides (SR20, CA18) Inside Ø 6.0 mm GDE-NSR6-I-8

Technical guide

The brand offered

SUPERTECH A racing valvetrain specialist for over 30 years, SUPERTECH designs stem seals, guides, valves and springs in San Jose, California. Ultrasound, X-ray and laser are used to check its production, which is then proven with renowned engine tuners.

Inlet or exhaust?

One seal size, two rubbers: VS-N6I polyacrylate (ACM) on the intake side, VS-N6E Viton (FKM) on the exhaust side, where valve heat peaks. SUPERTECH quotes 177 °C (350 °F) for polyacrylate and 204 °C (400 °F) continuous for Viton. These Nissan four-cylinders count 8 seals on each side, one for every valve, so two sets per engine.

When valve stem seals must be replaced

  • More frequent oil top-ups, blue cloud at start-up
  • Cylinder head being redone, valves out
  • Valve guides due for change
  • Build with uprated valves or springs

Vehicle compatibility

Nissan

ModelEngine codePowerYears
100NX (B13) SR20DE 143-150 hp 1990-1994
180SX (S13) CA18DE / CA18DET / SR20DE / SR20DET 132-208 hp 1988-1997
200SX (S13) CA18DE / CA18DET / SR20DE 135-169 hp 1988-1994
200SX (S14, S15) SR20DE / SR20DET 141-220 hp 1993-2002
Almera (N15, N16) SR20DE 125-145 hp 1995-2002
Almera Tino (V10) SR20DE 136 hp 2000-2003
Avenir (W10, W11) SR20DE / SR20DET 140-200 hp 1990-2006
Bluebird (T12, U13, U14) CA18DE / SR20DE / SR20DET / SR20VE 129-210 hp 1989-2002
Bluebird Sylphy (G10) SR20DE 145 hp 2000-2006
Lucino (N14, N15, B14) SR20DE / SR20DET 143-220 hp 1991-2000
Primera (P10, P11, P12, W10, WP11, WP12) SR20DE / SR20DEH / SR20DEL / SR20VE 115-204 hp 1990-2005
Pulsar NX CA18DE 133 hp 1987-1989
R'nessa / Altra (N30) SR20DE / SR20DET 140-200 hp 1997-2001
Sentra (B13, B15, N14) SR20DE / SR20DNE 143-150 hp 1992-2006
Serena (C23, C24) SR20DE 126-145 hp 1992-2005
Silvia (S13, S15) SR20DE / SR20DET 140-250 hp 1991-2003
Sunny (B12, N13, N14, N16) CA18DE / SR20DE / SR20DET 125-230 hp 1987-2002
Wingroad (Y11) SR20VE 190 hp 1999-2001

Infiniti

ModelEngine codePowerYears
G20 SR20DE 115-147 hp 1990-2002

OEM part number (Nissan SR20 and CA18 stem seals): 13207-84A00 (NDK) or 13207-D4201 (NOK); 13207-53F00 (NOK) from 1994 on the SR20DET and from 1996 on the SR20DE; SR20DEL and SR20DEH: 13207-89J00, superseded by 13207-84A00.

Important: this set of 8 does not suit the RB, VG30, VQ37VHR and VR38DETT six-cylinders (12 valves per side).

Remember the exhaust valve stem seals

Fitted in the same head, the exhaust seals wear alike: renew both together. SUPERTECH offers them for the SR20 and CA18:

Nissan SR20 CA18 exhaust valve stem seals →

16 other products in the same category

Viewed products

Loading...