Skip to content
  • On order
Jauge angulaire conique coupelle de ressort FERREA Jauge angulaire conique coupelle de ressort FERREA

FERREA T7000 valve spring retainer angle gauge

€39.85 (tax incl.)

FERREA gauge to identify the angle of a valve spring retainer, in steel or titanium.

  • Angles checked: 6°, 7°, Super 7 (8°), 10°
  • Material: hard-anodised aluminium
  • Use: unmarked retainers, check before fitting the collets
  • Sold: individually
T7000
For larger quantities, 5 to 15 days lead time
Pay in installments

The FERREA T7000 retainer angle gauge

The upper spring retainer holds the collets in a tapered bore. Its angle must be exactly the same as the collets: 6°, 7°, Super 7 or 10°. The FERREA T7000 gauge measures this angle on a steel or titanium retainer.

FERREA presented it at the 2019 PRI show, in its first range of engine assembly tools. It is mainly used when the marking on a retainer has worn off, or to sort a batch of unmarked retainers.

Why check the retainer angle

Collets fitted in a retainer of a different angle seat poorly: they hammer the valve groove and can break the retainer or the valve. Yet a 7° retainer and a Super 7 retainer, which actually measures 8°, are almost impossible to tell apart by eye. The gauge removes any doubt before assembly.

Technical specifications

BrandPart numberAngles checkedMaterialRetainers
FERREA T7000 6°, 7°, Super 7 (8°), 10° hard-anodised aluminium steel and titanium

Technical guide

How to use it

The gauge has four tapers: 7° and Super 7 on one side, 6° and 10° on the other.

  1. Slide the retainer onto the taper of the expected angle.
  2. If it seats without play, the retainer angle is the angle of that taper.
  3. If there is play, the retainer angle is larger than the taper, or the retainer is out of specification: try the next taper.

According to FERREA, this check saves having to test the retainer with the collets.

The brand

FERREA FERREA Racing Components, founded in 1978 in Florida by two Argentinian engine builders, Horacio Ferrea and Daniel Urrutia, makes its entire valvetrain in-house, from valves to springs, tappets and rocker arms. Its radial-groove collets, made of heat-treated alloy steel, are designed for its own valves and retainers.
Important: retainers and collets are always fitted with the same angle.

Don't forget the collets

Once the retainer angle is known, choose collets with the same angle, the same stem diameter and the same groove design as your valves:

6 mm valve collets →
7 mm valve collets →

2 other products in the same category

Viewed products

Loading...