Sort and filter
- Piston Pins, Circlips and Piston Rings
- KS Kolbenschmidt bearings
- Valve collets
- Graduated disc for camshaft timing
- Grease/Gasket for Reinforced Cylinder Head Bolts and Studs
- Shims for mechanical cam followers
- ARP Reinforced Crankshaft Bearing Bolts/Studs
- ARP reinforced connecting rod bolts
- ACL ref
- BY REFERENCE ARP - Reinforced cylinder head bolts/studs
- BY REFERENCE ATHENA - Reinforced cylinder head gaskets
- BY REFERENCE CATCAMS - Camshafts
- BY REFERENCE CATCAMS - Reinforced valve spring retainers
- BY REFERENCE CATCAMS - Mechanical Cam Followers
- BY REFERENCE CATCAMS - Reinforced Valve Springs
- BY REFERENCE COMETIC - Reinforced cylinder head gaskets
- BY REFERENCE FERREA - Reinforced valve spring retainers
- BY REFERENCE FERREA - Reinforced valve springs
- BY REFERENCE FERREA - Reinforced Valves
- BY REFERENCE NGK - Spark Plugs
- BY REFERENCE KENT CAMS - Reinforced Timing Belt
- BY REFERENCE SUPERTECH - Mechanical Cam Followers
- BY REFERENCE VIBRA-TECHNICS - Engine Mounts
- BY REFERENCE VIBRA-TECHNICS - Gearbox/transmission mount
Sort by:
Filter By
BY REFERENCE KENT CAMS - Reinforced Timing Belt
Kent Cams makes its belts in Britain for engines whose camshaft timing has been altered, with a pitch and a carcass able to take stiffer springs without jumping a tooth. Twenty-four part numbers are…Kent Cams makes its belts in Britain for engines whose camshaft timing has been altered, with a pitch and a carcass able to take stiffer springs without jumping a tooth. Twenty-four part numbers are active on this page. The numbering is a plain catalogue run, CB followed by two digits, from CB02 to CB33: no segment within it codes a manufacturer or a capacity. Selection therefore rests on the physical data of the belt, tooth count and width, taken off the fitted part or supplied by the engine builder. A reinforced belt removes none of the usual precautions: set the tension with the proper tool and renew the tensioner at the same time.